Dip-Switch Settings; Dip - Black; Activating The Front Camera Input (Dip 1); Enabling The Interface's Video Inputs (Dip 2-3) - NavLinkz RL4-MIB2-E18 Manual

1.5.

Dip-switch settings

1.5.1. 8 dip - black

Some settings have to be selected by the dip-switches on the
video interface.
Dip position down is ON and position up is OFF.
Dip Function
1 Front camera
Power supply
output
(red wire)
2 CVBS AV1-input
3 CVBS AV2-input
4 No function
5 Rear-view cam type
6
No function
7
Monitor adjusment
8
*The front camera will automatically be switched for 10 seconds after disengaging the
reverse gear 8see following information).
1.5.1.1.

Activating the front camera input (dip 1)

If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode.
Description of the front camera power supply: see chapter "Power supply output".
1.5.1.2.

Enabling the interface's video inputs (dip 2-3)

Only the enabled video inputs can be accessed when switching through the interface's video
sources. It is recommended to enable only the required inputs, disabled inputs
will be skipped when switching through the video-interfaces inputs.
1.5.1.3.

Rear-view camera setting (dip 5)

If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera.
If set to ON, the interface switches to its rear-view camera input
reverse gear is engaged.
Version 24.02.2021
ON (down)
enabled*
+12V (max. 3A) when reverse gear
is engaged incl. 10 seconds delay
and +12V by manual switching to
front camera by keypad
enabled
enabled
after-market
Try all 4 possible combinations of dip 7 and 8 to find the
best picture (quality and size)
HW CAM(V100) / (V35, V36, V40)
OFF (up)
disabled
+12V (max. 3A) ACC
disabled
disabled
Set to OFF
factory or none
Set to OFF
„Camera-IN" while the
RL4-MIB2-E18