Enabling The Video Input "Front Camera/Video In 1" (Dip 2); Enabling The Video Input "Video In 2" (Dip3); Rear-View Camera Setting (Dip 5); Activating The Front Camera Input (Dip 6) - NavLinkz RL2-SC14 Manual
Compatible with volvo vehicles with sensus connect infotainment and internet button with 7 inch monitor, video-inserter for front- and rear-view camera and one additional video source
Table of Contents
Advertisement
1.4.1.1.
Enabling the video input "Front camera/Video IN 1" (dip 2)
Only the enabled video inputs can be accessed when switching through the interface's video
sources. It is recommended to enable only the required inputs for the disabled will be
skipped when switching through the video-interfaces inputs.
If an after-market front camera is connected and Dip-2 is activated, it can also be switched
by external keypad, in addition to the automatic switch-back.
1.4.1.2.
Enabling the video input "Video IN 2" (dip3)
Only the enabled video inputs can be accessed when switching through the interface's video
sources. It is recommended to enable only the required inputs for the disabled will be
skipped when switching through the video-interfaces inputs.
1.4.2. Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera.
If set to ON, the interface switches to its rear-view camera input
reverse gear is engaged.
1.4.3. Activating the front camera input (dip 6)
If set to ON, the interface switches for 10 seconds from the rear-view camera input to the
front camera input after having disengaged the reverse gear.
If the front camera/V1 video input is activated by Dip-2, it is also possible to switch manually
from any picture mode to the front camera input, by pressing the button of the external
keypad (2-3 seconds).
1.4.4. Factory PDC settings (dip 8)
If set to ON while the reverse gage is enabled, the display shows a smaller reverse picture
and for that the factory PDC representation additionally appears on its right side. If set to
OFF while the reverse gage is enabled, the reverse picture will be shown in full size and the
PDC representation is disabled.
Note: Dip 1, 4und 7 are out of function and have to be set to OFF.
Version 09.02.2023
HW: CAM(V31)9275&9276(V11) since serial-no. NA210400258 with frontcam input
„Camera-IN"
while the
RL2-SC14
Advertisement
Table of Contents
