Activating The Front Camera (Dip 1); Enabling The Interface's Video Inputs (Dip 2-3); Rear-View Camera Setting (Dip5); Activating The Guide Lines (Dip6) - NavLinkz RL4-LR16-8 Manual

1.4.1. Activating the front camera (dip 1)

If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode.
Description of the power supply output: see chapter "Power supply output (only for RL4-LR16-10)".

1.4.2. Enabling the interface's video inputs (dip 2-3)

Only the enabled video inputs can be accessed by switching through the interface's video
sources. It is recommended to enable only the required inputs. So the disabled inputs will be
skipped while switching through the video interfaces inputs.

1.4.3. Rear-view camera setting (dip5)

If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.

1.4.4. Activating the guide lines (dip6)

If there is no communication between interface and the vehicle`s CAN-bus (several vehicles
aren't compatible), the reverse gear guide-lines can`t be shown during the vehicle's
operation, even if they once appear after having switched the system to powerless

1.4.5. Activating the PDC (dip7)

If set to ON, the PDC car will be displayed on the screen and the park distance will be shown
by using the signals of the vehicle's CAN-bus. If there is no communication between the
interface and the vehicle`s CAN-bus (several vehicles aren't compatible), the park distance
can't be shown. In this case, set dip7 to OFF.

1.4.6. Monitor selection (dip8)

Dip8 changes the monitor-specific video settings.
Using a 8inch monitor, the dip switch position is ON.
Using the 10,2inch monitor, the dip switch setting is OFF.
Note: Dip 4 is out of function and has to be set to OFF!
Version 17.02.2022
Size of monitor
8inch – INCONTROL TOUCH
10.2inch – INCONTROL TOUCH PRO
HW: CAM(V100)/(V20) and CAM(V100)/(V20)GD
Dip 8
ON
OFF
RL4-LR16-8/10