Adjustment - Power Supply Output (Dip 1); Enabling The Interface's Video Inputs (Dip 2-3); Rear-View Camera Setting (Dip 5); Activating - Front Camera Back Switching (Dip 6) - NavLinkz RL4-NAC08 Manual

1.6.1. Adjustment – power supply output (dip 1)
If set to ON, the video interfaces' red wire will supply +12V (max 3A) with engaging the
reverse gear and additionally 10 more seconds delay for the time of the front camera's back-
switching after the reverse gear has been disengaged. Furthermore, the red wire's power
supply for the front cam becomes active with manually front camera switching (short press
of the external keypad).
If set to OFF, the video interfaces' red wire will supply permanent +12V ACC (max 3A).
Description of the power supply output: see chapter "Power supply output".

1.6.2. Enabling the interface's video inputs (dip 2-3)

Only the enabled video inputs can be accessed by switching through the interface's video
sources. It is recommended to enable only the required inputs. Then the disabled inputs will
be skipped while switching through the video interfaces inputs.
1.6.3. Rear-view camera settings (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.6.4. Activating – front camera back-switching (dip 6)
If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode.
(Attend to correct adjustment of the power supply output (dip1)!
1.6.5. Head unit selection (Dip 8)
Dipswitch 8 is used to set the corresponding resolution of the factory monitor.
Dip switch position ON supports the low resolution monitor.
Dip switch position OFF supports the high resolution monitor.
Note: If you do not know the resolution, test both settings.
Note: Dip4 and 7 are out of function and have to be set to OFF.
After each Dip-switch-change a power-reset of the interface box has to be performed!
Version 26.05.2023 HW: CAM(V100)/(V52) RL4-NAC08