Cleaning Quartz Sleeve & Lamp Sensor (cont.)
IF calcium deposits are encountered, rinse quartz sleeves with tap water, then clean
with Lime-A-Way®, Muriatic Acid (4 parts water – 1 part acid), or isopropyl alcohol.
Step 9
Step 10
Loosen the vessel lock nut, rotating counter
Pinch the sleeve near the clips to spring it loose
clockwise & pull the sleeve straight out.
& carefully slide it straight off.
Step 11
Step 12
Rinse/clean the outside of the quartz sleeve
Once dry, inspect the quartz sleeves for cracks,
ONLY*, then clean with rubbing alcohol or
IF any cracks exist immediately replace (DO
muriatic acid DO NOT use abrasives.
NOT install cracked quartz sleeves).
*IMPORTANT: DO NOT clean or get the inside of the quartz sleeves wet or dirty, inside the
24
sleeve is normally sealed and does not require cleaning.