Prolonged exposure to the eyes can cause serious injury to the eyes, including blindness. DO NOT VIEW UV LAMP WHILE THE DEVICE IS IN OPERATION. SAVE THESE INSTRUCTIONS • USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
How the Hayward HydroRite Works The Hayward HydroRite contains a high intensity electrically operated Ultraviolet (UV) lamp which is located inside the unit’s wet chamber. The UV lamp emits light at two separate wavelengths within the UV spectrum; 254 nm and 185 nm. The 254 nm wavelength is called the “germicidal” wavelength. This wavelength is capable of inactivating a wide array of microorganisms such as bacteria, viruses, protozoa (e.g.
HydroRite unit and its installation may save a great deal of time (and expense) later. If you have any questions that are unanswered when you have completed the reading of this manual, contact your supplier or Hayward.
Page 5
Plumbing the HydroRite System Although not required, Hayward recommends that the HydroRite system be plumbed in a dedicated loop that can be bypassed as shown on page 3. A three-way valve and actuator are supplied for this purpose. If plumbing a bypass, a tee fitting will be required. A bypass will aid in servicing and maintaining the HydroRite.
The venturi tube is made of a specific material suitable for its purpose. If replacing the attached, insert tube or if a longer tube is needed, call Hayward Technical Support at 908-355-7995. lamp into the sleeve Ballast Cable and UV Lamp DO NOT TOUCH THE UV LAMP WITH YOUR BARE HANDS.
Page 7
HydroRite uses a linecord for input power and must be plugged into a 120V 50/60hz GFCI protected outlet. NOTE: Should the electrical power cord of your HydroRite unit become frayed or damaged, unplug it from the power receptacle and contact Hayward. USE OF A FRAYED OR DAMAGED POWER CORD COULD RESULT IN ELECTRICAL SHOCK CAUSING SERIOUS BODILY INJURY, INCLUDING DEATH.
Cleaning the sleeve should return HydroRite to previous performance. Hayward recommends that you remove the lamp and clean the sleeve every 1-3 months depending on the condition of your pool’s water. The sleeve may need more frequent cleaning in areas of the country that have hard water. The quartz sleeve can be manually cleaned or cleaned with an in-line automatic cleaner.
Page 9
(see adjacent diagram). Pinching the baffle at those points will flex the surface enough to “unhook” itself from the light engine. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
Page 10
In other instances, the supplier will refer you to Hayward, who can assist you as well. Please read the Limited Warranty in this manual for your HydroRite unit. It explains fully what is and what is not covered under the Limited Warranty and the warranty periods.
Is the HydroRite System Designed For Salt Water Use? YES, all plastic components are compatible with pools equipped with Hayward Salt Chlorine Generator Systems. Over time, the stainless steel baffle can be affected by a high salt environment but can be easily replaced if necessary.
Make sure you have not plugged your device into any power source other than that specified on your device’s electrical label. If you have done so in error, the ballast has been damaged and needs to be replaced. Contact your supplier or Hayward for the correct replacement ballast. A replacement ballast is not warranted.
The express limited warranty above constitutes the entire warranty of Hayward Pool Products with respect to its pool products and is in lieu of all other warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose. In no event shall Hayward Pool products be responsible for any consequential, special or incidental damages of any nature.