Hayward HydroRite UVO3 Troubleshooting Manual page 14

HydroRite: Menu & Reports/Errors
Menu Description
Calibration (only to be used after
CAL
replacing all three lamps)
S Test = Direct voltage readout
Test = voltage readout that was
dSP
obtained at calibration
Audible alarm for flow switch &
Aud
interlock sensor (ON/OFF)
Hours of lamp operation since the
run
last calibration
14
Menu Button
Enter Button / Silence Alarms
Lamp Operation (Auto or OFF)
Report Description
OF Indicates that the lamp is in an OFF cycle (Manual)
P Appears if the HydroRite passed calibration
F Appears if the HydroRite failed calibration
FLO A no flow or interlock condition has been identified
SyS... System error: the lamp intensity has fallen below
Err... 70% of the intensity reported during initial
XX calibration
Stands for high temperature condition related to
TeP
the internal controller temperature.