Using The Cli To View Rf Group Status - Cisco OL-8335-02 Configuration Manual

Chapter 9 Configuring Radio Resource Management
The top of this page shows the details of the RF group, specifically how often the group information is
updated (600 seconds by default), the MAC address of the RF group leader, whether this particular
controller is the group leader, the last time the group information was updated, and the MAC addresses
of all group members.
Note
If desired, repeat this procedure for the network type you did not select (802.11a or 802.11b/g).
Step 4

Using the CLI to View RF Group Status

Follow these steps to view the status of the RF group using the CLI.
Enter show advanced 802.11a group to see which controller is the RF group leader for the 802.11a RF
Step 1
network. Information similar to the following appears:
Radio RF Grouping
This text shows the details of the RF group, specifically whether automatic RF grouping is enabled for
this controller, how often the group information is updated (600 seconds by default), the MAC address
of the RF group leader, the MAC address of this particular controller, and the last time the group
information was updated.
Note
Enter show advanced 802.11b group to see which controller is the RF group leader for the 802.11b/g
Step 2
RF network.
OL-8335-02
Automatic RF grouping, which is set through the Group Mode check box, is enabled by default.
See Table 9-1 for more information on this parameter.
802.11a Group Mode............................. AUTO
802.11a Group Update Interval.................. 600 seconds
802.11a Group Leader........................... 00:16:9d:ca:d9:60
802.11a Group Member........................... 00:16:9d:ca:d9:60
802.11a Last Run............................ 594 seconds ago
If the MAC addresses of the group leader and the group member are identical, this controller is
currently the group leader.
Cisco Wireless LAN Controller Configuration Guide
Viewing RF Group Status
9-11