Chapter 3
Configuring Ports and Interfaces
AP-Manager Interface
VLAN identifier
•
Note
•
Fixed IP address, IP netmask, and default gateway
Note
Physical port assignment
•
Primary and secondary DHCP servers
•
Access control list (ACL) name, if required
•
Note
Virtual Interface
Any fictitious, unassigned, and unused gateway IP address, such as 1.1.1.1
•
DNS gateway host name
•
Service-Port Interface
Note
DHCP protocol (enabled) or
•
DHCP protocol (disabled) and IP address and IP netmask
•
Click Save Configuration to save your changes.
Step 4
If you made any changes to the virtual interface, reboot the controller so your changes take effect.
Step 5
OL-8335-02
Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
that only tagged VLANs be used on the controller.
The AP-manager interface's IP address must be different from the management interface's
IP address but must be on the same subnet as the management interface.
To create ACLs, follow the instructions in
The service-port interface uses the controller's factory-set service-port MAC address.
Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
Chapter
Cisco Wireless LAN Controller Configuration Guide
5.
3-11