Cisco OL-8335-02 Configuration Manual page 170

Enabling Rogue Access Point Detection
Figure 9-7
The name of the RF group to which this controller belongs appears at the bottom of the page.
Check the Enable AP Neighbor Authentication check box to enable rogue access point detection.
Step 7
Enter a number in the Alarm Trigger Threshold edit box to specify when a rogue access point alarm is
Step 8
generated. An alarm occurs when the threshold value (which specifies the number of access point frames
with an invalid authentication IE) is met or exceeded within the detection period.
Note
Click Save Configuration to save your changes.
Step 9
Repeat
Step 10
Note
Cisco Wireless LAN Controller Configuration Guide
9-14
AP Authentication Policy Page
The valid threshold range is from1 to 255, and the default threshold value is 1. To avoid false
alarms, you may want to set the threshold to a higher value.
Step 2 through Step 9 on every controller in the RF group.
If rogue access point detection is not enabled on every controller in the RF group, the access
points on the controllers with this feature disabled are reported as rogues.
Chapter 9 Configuring Radio Resource Management
OL-8335-02