Using Client Reason And Status Codes In Trap Logs; Client Reason Codes - Cisco OL-8335-02 Configuration Manual

Using Client Reason and Status Codes in Trap Logs

Table D-1
Error Message
SENSED_TEMPERATURE_LOW
TEMPERATURE_SENSOR_FAILURE
TEMPERATURE_SENSOR_CLEAR
POE_CONTROLLER_FAILURE
MAX_ROGUE_COUNT_EXCEEDED
SWITCH_UP
SWITCH_DOWN
RADIUS_SERVERS_FAILED
CONFIG_SAVED
MULTIPLE_USERS
FAN_FAILURE
POWER_SUPPLY_CHANGE
COLD_START
WARM_START
Using Client Reason and Status Codes in Trap Logs
The WCS Clients > Detail page lists the reason and status codes that you are likely to encounter when
reviewing the trap logs.
codes and descriptions.

Client Reason Codes

This table lists client reason codes.
Table D-2
Client
Reason
Code
0
1
Cisco Wireless LAN Controller Configuration Guide
D-4
System Messages and Descriptions (continued)
Table D-2 lists client reason codes and descriptions. Table y lists client status
Client Reason Code Descriptions and Meanings
Description
noReasonCode
unspecifiedReason
Appendix D System Messages and Access Point LED Patterns
Description
Check room temperature and/or other reasons for
low temperature.
Replace temperature sensor ASAP.
Temperature sensor is operational.
Check ports — possible serious failure detected.
The current number of active rogue access points
has exceeded system threshold.
Controller is responding to SNMP polls.
Controller is not responding to SNMP polls, check
controller and SNMP settings.
Check network connectivity between RADIUS
and the controller.
Running configuration has been saved to flash -
will be active after reboot.
Another user with the same username has logged
in.
Monitor Cisco Wireless LAN Controller
temperature to avoid overheating.
Check for power-supply malfunction.
Cisco Wireless LAN Controller may have been
rebooted.
Cisco Wireless LAN Controller may have been
rebooted.
Meaning
Normal operation.
Client associated but no longer authorized.
OL-8335-02