Cisco OL-8335-02 Configuration Manual page 104

Configuring the Supervisor 720 to Support the WiSM
Command
Step 7
interface port-channel 2
switchport trunk
a.
encapsulation dot1q
switchport trunk native vlan
b.
vlan
switchport mode trunk
c.
end
d.
Step 8 interface GigabitEthernet9/1-4
switchport trunk
a.
encapsulation dot1q
switchport trunk native vlan
b.
vlan
switchport mode trunk
c.
channel-group 1 mode on
d.
Step 9 interface GigabitEthernet9/5-8
switchport trunk
a.
encapsulation dot1q
switchport trunk native vlan
b.
vlan
switchport mode trunk
c.
channel-group 2 mode on
d.
Step 10 interface vlan
Step 11 ip address ip-address gateway
Step 12
end
Step 13 wism service-vlan vlan
Step 14 end
Step 15 show wism status
Cisco Wireless LAN Controller Configuration Guide
4-12
Purpose
Configure a port-channel to bundle the automatically created
Gigabit interfaces 5-8 into an etherchannel.
Configure the second port-channel as the first.
Return to global config mode.
Establish a separate Gigabit etherchannel for the first controller
on the WiSM. For the native VLAN on the ports, configure the
VLAN that you created for communicating with the WiSM data
ports.
Configure the previously created port-channel interfaces as trunk
ports. For the native VLAN on the ports, configure the VLAN that
you created for communicating with the WiSM data ports.
Bind the physical GigabitEthernet interfaces to the logical
port-channel interface.
Establish a separate Gigabit etherchannel for the second
controller on the WiSM. For the native VLAN on the ports,
configure the VLAN that you created for communicating with the
WiSM data ports.
Configure the second group of GigabitEthernet interfaces as the
first.
Bind the physical GigabitEthernet interfaces to the logical
port-channel interface.
Create a VLAN to communicate with the service ports on the
WiSM.
Assign an IP address and gateway to the VLAN.
Return to global config mode.
Configure the VLAN that you created in step 10 to communicate
with the WiSM service ports.
Return to global config mode.
Verify that the WiSM is operational.
Chapter 4 Configuring Controller Settings
OL-8335-02