Configuring Ports - Cisco OL-8335-02 Configuration Manual

Chapter 3 Configuring Ports and Interfaces
Enter show interface detailed operator-defined-interface-name and show interface summary to verify
Step 5
that your changes have been saved.
Note If desired, you can enter config interface delete operator-defined-interface-name to delete a dynamic
interface.

Configuring Ports

The controller's ports are preconfigured with factory default settings designed to make the controllers'
ports operational without additional configuration. However, you can view the status of the controller's
ports and edit their configuration parameters at any time.
Follow these steps to use the GUI to view the status of the controller's ports and make any configuration
changes if necessary.
Click Controller > Ports to access the Ports page (see
Step 1
Figure 3-8
This page shows the current configuration for each of the controller's ports.
If you want to change the settings of any port, click the Edit link for that specific port. The Port >
Step 2
Configure page appears (see
Note
OL-8335-02
Ports Page
Figure
The number of parameters available on the Port > Configure page depends on your controller
type. For instance, Cisco 2000 series controllers and the controller in a Cisco Integrated Services
Router have fewer configurable parameters than a Cisco 4400 series controller, which is shown
in Figure 3-9.
Figure
3-9).
Cisco Wireless LAN Controller Configuration Guide
Configuring Ports
3-8).
3-17