Enabling Wireless Connections To The Web-Browser And Cli Interfaces - Cisco OL-8335-02 Configuration Manual

Enabling Wireless Connections to the Web-Browser and CLI Interfaces

Enabling Wireless Connections to the Web-Browser and
CLI Interfaces
You can monitor and configure controllers using a wireless client. This feature is supported for all
management tasks except uploads from and downloads to the controller.
Before you can open the GUI or the CLI from a wireless client device you must configure the controller
to allow the connection. Follow these steps to enable wireless connections to the GUI or CLI:
Log into the CLI.
Step 1
Enter config network mgmt-via-wireless enable
Step 2
Use a wireless client to associate to a lightweight access point connected to the controller.
Step 3
On the wireless client, open a Telnet session to the controller, or browse to the controller GUI.
Step 4
To use the controller GUI to enable wireless connections, browse to the Management Via Wireless page
Tip
and select the Enable Controller Management to be accessible from Wireless Clients check box.
2-8
Chapter 2 Using the Web-Browser and CLI Interfaces
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02