AEG BSE577121M User Manual page 5

Hide thumbs Also See for BSE577121M:
Table of Contents

Advertisement

Cabinet depth
Height of the front of
the appliance
Height of the back of
the appliance
Width of the front of
the appliance
Width of the back of
the appliance
Depth of the appli-
ance
Built in depth of the
appliance
Depth with open
door
Ventilation opening
minimum size. Open-
ing placed on the
bottom rear side
Mains supply cable
length. Cable is
placed in the right
corner of the back
side
Mounting screws
2.2 Electrical connection
WARNING!
Risk of fire and electric
shock.
• All electrical connections should be
made by a qualified electrician.
• The appliance must be earthed.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to
the mains plug and to the mains
cable. Should the mains cable need
550 (550) mm
• Do not let mains cables touch or
594 mm
576 mm
• The shock protection of live and
595 mm
• Connect the mains plug to the mains
559 mm
569 mm
• If the mains socket is loose, do not
548 mm
• Do not pull the mains cable to
1022 mm
• Use only correct isolation devices: line
560x20 mm
• The electrical installation must have
1500 mm
• Fully close the appliance door before
• This appliance is supplied with a main
4x25 mm
For the section of the cable refer to the
total power on the rating plate. You can
also refer to the table:
to be replaced, this must be carried
out by our Authorised Service Centre.
come near the appliance door or the
niche below the appliance, especially
when it operates or the door is hot.
insulated parts must be fastened in
such a way that it cannot be removed
without tools.
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
connect the mains plug.
disconnect the appliance. Always pull
the mains plug.
protecting cut-outs, fuses (screw type
fuses removed from the holder), earth
leakage trips and contactors.
an isolation device which lets you
disconnect the appliance from the
mains at all poles. The isolation
device must have a contact opening
width of minimum 3 mm.
you connect the mains plug to the
mains socket.
plug and a main cable.
Cable types applicable for installation
or replacement for Europe:
H07 RN-F, H05 RN-F, H05 RRF, H05 VV-F,
H05 V2V2-F (T90), H05 BB-F
Total power (W)
maximum 1380
maximum 2300
maximum 3680
ENGLISH
5
Section of the ca-
ble (mm²)
3 x 0.75
3 x 1
3 x 1.5

Advertisement

Table of Contents
loading

Table of Contents