Table of Contents
Advertisement
12
www.aeg.com
Oven function Application
Pyrolysis
7.3 Setting a heating function
1. Turn the knob for the heating
functions to select a heating function.
2. Turn the control knob to select the
temperature.
The lamp turns on when the oven
operates.
3. To turn off the oven, turn the knob
for the heating functions to the off
position.
7.4 Fast Heat Up
The fast heat up decreases the heat up
time.
Do not put food in the oven
when the Fast heat up
operates.
1. Turn the knob for the oven functions
to set the fast heat up.
2. Turn the knob for the temperature to
set the temperature.
The signal sounds when the oven is at
the set temperature.
3. Set an oven function.
7.5 Heat-up indicator
When the oven function operates, the
bars in the display
when the temperature in the oven
increases, and disappear when it
decreases.
7.6 Steam Cooking
Use only water. Do not use
filtered (demineralised) or
distilled water. Do not use
other liquids. Do not put
flammable or alcoholic
liquids into the water
drawer.
1. Set the function
To turn on the pyrolytic
cleaning of the oven. This
function burns off residu-
al dirt in the oven.
appear one by one
.
2. Press the cover of the water drawer
to open it.
3. Fill the water drawer with water until
the display shows Tank Full indicator.
The maximum capacity of the tank is
900 ml. It is sufficient for
approximately 55 - 60 minutes of
cooking.
4. Push the water drawer to its initial
position.
5. Set the temperature between 130 °C
and 230 °C.
Steam cooking gives good results
with this temperature range.
6. Empty the water tank after the steam
cooking is completed.
Wait for at least 60 minutes after each
use of the steam function to prevent hot
water from exiting the water outlet valve.
CAUTION!
The appliance is hot. There
is a risk of burns. Be careful
when you empty the water
drawer.
7.7 Water tank indicator
While steam cooking, Water Tank
indicator in the display shows the level of
the water in the tank.
• When the tank is full the display
shows
and a signal sounds. Press
any button to stop the signal.
• When the tank is half full the display
shows
.
• When the tank is empty the display
shows
and a signal sounds. Refill
the tank.
If you put too much water
into the tank, the safety
outlet moves the excess
water to the bottom of the
oven.
Remove the water with a
sponge.
7.8 Emptying the water tank
CAUTION!
Make sure that the oven is
cold before you start to
empty the water tank.
Advertisement
Table of Contents
