Configure The Router; Perform A Basic Configuration Using The Setup Facility; Configure Global Parameters - Cisco 7304 Quick Start Manual

7

Configure the Router

Perform a Basic Configuration Using the Setup Facility

You can run the setup facility any time you are at the enable prompt (#) by entering the setup command.
The router may take several minutes to determine that AutoInstall is not set up to a remote TCP/IP host. Once the router
determines that AutoInstall is not configured, it defaults to the setup facility.

Configure Global Parameters

When you first start the setup program, you must configure the global parameters. These parameters are used for controlling
system-wide settings. Complete the following steps to enter the global parameters:
Step 1 Connect a console terminal to the console port, and then boot the router.
The system boots from Flash memory. The following information appears after about 30 seconds. When you see this
information, you have successfully booted your router:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 7300 Software (C7300-JS-M), Version 12.1(9), CISCO RELEASED VERSION
TEST VERSION
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Tue 17-Jul-01 01:51 by biff
Image text-base:0x40008970, data-base:0x40BF8000
Downloading default microcode:system:pxf/ucode1
Successfully downloaded the production microcode.
updating timeout values directly
Currently running ROMMON from OTP ROM
cisco 7300 (NSE100) processor (revision B) with 114688K/16384K bytes of memory.
Processor board ID
R7000 CPU at 350Mhz, Implementation 39, Rev 3.2, 256KB L2, 1024KB L3 Cache
4 slot midplane, Version 65.48
Last reset from watchdog nmi
X.25 software, Version 3.0.0.
PXF processor tmc0 is running.
PXF processor tmc1 is running.
1 FastEthernet/IEEE 802.3 interface(s)
2 Gigabit Ethernet/IEEE 802.3 interface(s)
9 Packet over SONET network interface(s)
509K bytes of non-volatile configuration memory.
16064K bytes of ATA compact flash disk at bootdisk (Sector size 512 bytes).
64000K bytes of ATA compact flash disk at disk 0 (Sector size 512 bytes).
Press RETURN to get started!
29