Replacing the DIMM
This section provides the following procedures:
"To Remove the Existing DIMM" on page 2
"To Install the New DIMM" on page 5
To Remove the Existing DIMM
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Remove the blade cover screws (
Use a Phillips No. 2 screwdriver to remove the screws.
FIGURE 1
2
Sun Fire B1600 Blade System Chassis DIMM Replacement Guide For The B200x Blade • July 2003
Removing the Blade Cover Screws
).
FIGURE 1