Prevent Electrostatic Discharge; Remove Power; Selecting A Location - Spectrum Controls Micro800 2085-OB32-SC User Manual

Expansion i/o 32-point 24 v sink/source discrete output modules
Table of Contents

Advertisement

2.2.2 Prevent Electrostatic Discharge

Electrostatic discharge can damage integrated circuits or semiconductors if
WARNING
you touch the module card bus connector pins or the terminal block on the
output module. Follow these guidelines when you handle the module:

2.2.3 Remove Power

This module is not designed to be hot-swapped and may be damaged
WARNING
if added or removed while power is applied. Remove power before
removing or inserting this module.
When you remove or insert a module with power applied, an electrical arc
may occur. An electrical arc can cause personal injury or property damage
by:

2.2.4 Selecting a Location

Reducing Noise
Most applications require installation in an industrial enclosure to reduce the
effects of electrical interference. Group your modules to minimize adverse
effects from radiated electrical noise and heat. Consider the following conditions
when selecting a location for the analog module. Position the module:
In addition, route wiring away from any high-voltage I/O wirin.
Touch a grounded object to discharge static potential.
Wear an approved wrist-strap grounding device.
Do not touch the bus connector or connector pins.
Do not touch circuit components inside the module.
If available, use a static-safe workstation.
When it is not in use, keep the module(s) in a static-shield bag.
Sending an erroneous signal to your system's field devices,
causing unintended machine motion.
Causing an explosion in a hazardous environment.
Causing an electrical arc. Electrical arcing causes excessive wear
to contacts on both the module and its mating connector and may
lead to premature failure
Away from sources of electrical noise such as hard-contact switches,
relays, and AC motor drives.
Chapter 2: Installation and Wiring
.
User's Manual Pub. 0300309-01 Rev. B
2-3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Micro800 2085-OB32-SC and is the answer not in the manual?

This manual is also suitable for:

Micro800 2085-ov32-sc

Table of Contents