Table of Contents
Advertisement
Instructions for use DIAGNOcam Vision Full HD
8 Accessories | 8.1 Foot Control Vision Full HD
▶ If the automatic installation is aborted, the device drivers have to be manu-
ally installed.
ð
The installation can take up to several minutes depending on the system.
ð
During installation, a red LED lights up on the receiver. This means "there is
still no connection to the transmitter", the device is not ready yet.
ð
As soon as the red LED goes out, the foot control is ready for use.
Red LED: The USB stick is being installed or there is
no connection to the foot control.
Green LED: The foot control is activated, the signal
is received. The LED lights up as long as a signal is
received.
Battery insert/replace
▶ To start up the transmitter or replace the battery, remove the 4 screws ①
in the bottom of the foot control.
▶ Remove bottom cover.
▶ Insert the AAA batteries ②, paying attention to the correct polarity ③.
1
1
1
1
① 4 screws
② Battery compartment
ð
The transmitter is now ready for operation and connects to the receiver.
▶ Then attach the bottom cover and screw it back with the 4 screws ①.
▶ Press the foot control.
ð
When the foot control is pressed, a green LED lights up on the receiver.
ð
The receiver receives the signal from the foot control.
ð
The LED lights up as long as the foot control is pressed.
Transmitter and receiver are factory programmed and paired, which means
that a function with other Bluetooth devices is not possible.
8.1.6 Operate foot control
▶ Press the foot control.
ð
When the foot control is pressed, a green LED lights up on the receiver.
2
2
③ polarity of the batteries
44 / 52
3
3
3
3
Advertisement
Table of Contents
