Safety; Infection Hazard; Technical Condition; Accessories And Combination With Other Equipment - KaVo DIAGNOcam Vision Full HD Instructions For Use Manual

2 Safety

Note
All serious events occurring in relation to the product must be reported to the
manufacturer and the competent authority of the member state, in which the
user and/or patient resides.
The instructions for use are a component of the product and must be read care-
fully prior to use and be accessible at all times.
The device may only be used in accordance with the intended use, any other
type of use is not permitted.

2.1 Infection hazard

Patients, users or third parties could be infected by contaminated medical
devices.
▶ Take suitable personal protective measures.
▶ Follow the instructions for use of the components.
▶ Before initial startup and after each use, reprocess the product and ac-
cessories appropriately.
▶ Carry out the reprocessing as described in the instructions for use. The pro-
cedure has been validated by the manufacturer.
▶ If you deviate from this procedure, it is essential to make sure that the re-
processing is effective.
▶ Reprocess the product and accessories appropriately before disposal.

2.2 Technical condition

A damaged device or components could injure patients, users and third parties.
▶ Only operate devices or components if they are undamaged on the outside.
▶ Check that the device is working properly and is in satisfactory condition
before each use.
▶ Have parts with sites of breakage or surface changes checked by the Ser-
vice.
▶ Do not pull on the USB cable and do not kink the cable.
▶ If product irregularities occur, immediately shut down the product and have
the service personnel carry out repair work.
▶ If image faults occur, immediately shut down the product and have the ser-
vice personnel carry out repair work.

2.3 Accessories and combination with other equipment

Use of un-authorised accessories or un-authorised modifications of the device
could lead to injury.
▶ Only use accessories that have been approved for combination with the
product by the manufacturer.
▶ Only use accessories that are equipped with standardised interfaces.
▶ Only use consumables that have been approved for combination with the
product by the manufacturer.
▶ Do not make any modifications to the device unless these have been ap-
proved by the manufacturer of the product.
Instructions for use DIAGNOcam Vision Full HD
11 / 52
2 Safety | 2.1 Infection hazard