Troubleshooting Tools - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Troubleshooting Tools

The following table shows the general troubleshooting strategy described in this chapter. Refer to
this table, as necessary, to follow the steps to isolate problems to a specific subsystem and resolve
the problem if possible.
Table 8-1
Step 1 Turn power on. Go to Step 2
Step 2 Power A/Power B LEDs on?
Step 3 Status LED red (failure)
Step 4
Step 5
Step 6
Troubleshooting Tools
There are three tools that will help you to successfully troubleshoot your SCE 2000 installation:
Cisco SCE 2000 4xGBE Installation and Configuration Guide
8-2
Troubleshooting Strategy for Startup Problems
Action
Management interface
operational?
Link interfaces operational?
System startup successful (all
interfaces operating normally).
CLI Commands for Troubleshooting
•
• The User Log (on page 8-4)
Check the LEDs (on page 8-7)
•
Yes No
Go to Step 3 Refer to
power subsystem
("Troubleshooting the Power
Subsystem" on page 8-9) and
go to Step 3.
Refer to Go to Step 4
Troubleshooting
the firmware
package
installation (on
page 8-11) and go
to Step 4.
Go to Step 5 Refer to
management subsystem
("Troubleshooting the
Management
page 8-12) and go to Step 4.
Go to Step 6 Refer to
link interface subsystem
("Troubleshooting the Link
Interface
8-14) and go to Step 5.
⎯ ⎯
(on page 8-3)
Chapter 8 Troubleshooting
Troubleshooting the
Troubleshooting the
Subsystem" on
Troubleshooting the
Subsystem" on page
OL-7824-04