Recovering A Previous Configuration - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Managing SCE 2000 Configurations

Recovering a Previous Configuration

When you save a new configuration, the system automatically backs up the old configuration in
the directory tffs0:system/prevconf/. Up to nine versions of the startup configuration
file are saved, namely config.tx1-config.tx9, where config.tx1 is the most recently
saved file.
You can view the old startup configuration files using the CLI command more.
Restoring a previous startup configuration means renaming the file so it overwrites the startup
configuration (config.txt) file.
To restore a previous startup configuration, complete the following steps:
Step 1 At the SCE 2000# prompt, type more tffs0:system/prevconf/config.txt to view
the configuration file.
The system displays the configuration information stored in the file.
Read the configuration information to make sure it is the configuration you want to restore.
Step 2
Note that you cannot undo the configuration restore command.
Type
Step 3
copy tffs0:system/prevconf/config.tx1 tffs0:system/config.txt.
The system sets the startup configuration to the configuration from config.tx1.
E
XAMPLE
The following example displays a saved configuration file and then restores the file to overwrite
the current configuration.
SCE 2000#more tffs0:system/prevconf/config.tx1
#This is a general configuration file (running-config).
#Created on 19:36:07 UTC THU February 14 2002
#cli-type 1
#version 1
interface LineCard 0
no silent
no shutdown
interface FastEthernet 0/0
ip address 10.1.5.109 255.255.0.0
interface FastEthernet 0/1
interface FastEthernet 0/2
exit
line vty 0 4
exit
SCE 2000#copy tffs0:system/prevconf/config.tx1 tffs0:system/config.txt
SCE 2000#
Cisco SCE 2000 4xGBE Installation and Configuration Guide
7-8
:
Chapter 7 Basic SCE 2000 Platform Operations
OL-7824-04