Removing The Fan Module; Replacing The Fan Module - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Chapter 4 Installation and Maintenance
Do not remove or install modules without using appropriate anti-static guard measures. The SCE 2000
ESD Warning
includes an anti-static wrist strap in the accessory kit. Attach the copper tape strap to an unpainted metal
surface on the chassis. You may leave the strap connected to the chassis when your have finished.

Removing the Fan Module

When removing the fan drawer, keep hands and fingers away from the spinning fan blades. Let the fan
Warning
blades stop completely before removing the fan drawer.
To remove the fan module, complete the following steps:
Step 1 Using a 1/4-inch flat-blade screwdriver, loosen the two captive screws on the faceplate of the fan
module.
Step 2 Grasp the fan module handle and remove it from the router.
This completes the procedure for removing the fan module from a SCE 2000 platform.

Replacing the Fan Module

To install a new fan module into a SCE 2000 platform, complete the following steps:
Step 1 Grasp the fan module handle with one hand and place your other hand underneath the fan module
for support. The handle of the unit should be at the bottom.
Step 2 Fit the groove in the side of the new fan module into the guide in the chassis.
Gently, but firmly, slide the module into the chassis until its faceplate is flush with the chassis rear
Step 3
panel.
Figure 4-17: Inserting the Fan Module
OL-7824-04
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Fan Module Overview
4-21