Cisco SCE 2000 4xGBE Installation And Configuration Manual page 83

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Enter admin status of the SCE after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
The following examples present the procedure for configuring the topology-related parameters for
various topologies.
E
XAMPLE
Following is a sample topology configuration for a non-redundant topology using an optical
splitter, that is, a single SCE 2000 connected in receive-only connection mode, to one or two GBE
links
Would you like to enter the Topology configuration menu? [no]: y
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]: 2
Is this a cascade deployment? [no]: no
Enter admin status of the SCE after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]: 1
Data collection for the system configuration is completed.
All other parameter values are automatically assigned by the system.
E
XAMPLE
Following is a sample topology configuration for a non-redundant inline topology. In this
topology, a single SCE 2000 is connected to one or two GBE links.
When the inline connection mode is specified, the user must specify the on-failure link behavior.
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]: 1
Is this a cascade deployment? [no]: no
Enter On-failure behavior:
1- bypass
2- cutoff
Enter your choice [1]: 1
Enter admin status of the SCE after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]: 1
Data collection for the system configuration is completed.
OL-7824-04
To specify Operational status after abnormal boot, press Enter.
•
• To specify Not-Operational status after abnormal boot, type 2 and press Enter.
#1:
#2:
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-21