Configuring The Gbe Interface Parameters - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Connecting the line ports to the network
Inline topologies require connecting both Receive and Transmit fibers to the SCE 2000. Cascade
ports always require both Receive and Transmit fibers to be connected.
The following diagram illustrates the connections for a dual link, two SCE 2000 inline topology
Figure 6-5: Cabling Diagram: Dual Link Inline Topology Two Cascaded SCE 2000s

Configuring the GBE Interface Parameters

By default, the SCE 2000 GBE line interface ports are configured with auto-negotiation disabled.
The procedure for enabling auto-negotiation for the GBE line interface ports is explained in the
following section.
Auto-negotiation must be disabled when the SCE 2000 is deployed via an external optical splitter
Note
(receive-only topology)
.
If you change any parameters, you must save the new configuration settings.
Note
Type copy running-config startup-config, and press Enter
Cisco SCE 2000 4xGBE Installation and Configuration Guide
6-6
Chapter 6 Cabling the Line Ports and Completing the Installation
OL-7824-04