Cisco SCE 2000 4xGBE Installation And Configuration Manual page 71

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
To configure the time settings, complete the following steps:
Enter the time settings menu.
Step 1
Would you like to enter the Time settings menu? [no]: y
Type y and press Enter.
The time settings dialog begins.
Step 2 Type the time zone abbreviation and press Enter.
Enter time zone name [UTC]: CET
Step 3 Type the minutes offset from UTC and press Enter.
Enter time zone minutes offset from UTC: 60
The local time and date are displayed, and you are asked whether you want to change them.
The local time and date is 15:00:01 CET FRI 01 July 2002
Would you like to set a new time and date? [no]:
Step 4 If the time and date are correct, go to step 5.
If the time and date are not correct, answer yes to the above question, and press Enter.
Would you like to set a new time and date? [no]: y
Confirm your response and type the new time and date.
This change will take effect immediately both on the system clock and the
calendar; it will also set the time zone you entered. Are you sure?
[yes/no]: y
Enter new local time and date: 14:00:01 1 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
Step 5 You are asked whether you wish to enter the SNTP configuration menu.
If you do not wish to configure the SNTP, skip the rest of this section and go to
Configuring the DNS Settings
To enter the SNTP configuration dialog, type y, and press Enter
Would you like to enter the SNTP configuration menu? [no]: y
Step 6 Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
Enable SNTP broadcast client? [no]:
Define the time interval between unicast updates.
Step 7
Enter time interval in seconds between unicast updates [1024]:
You may enter an IP address for the SNTP unicast server. Type in the hostname or the IP address
Step 8
in the form x.x.x.x, and press Enter
Would you like to configure SNTP unicast servers? [no]: y
Enter IP address or hostname of SNTP unicast server: 10.1.1.1
OL-7824-04
To disable the SNTP broadcast client, press Enter.
•
To enable the SNTP broadcast client, type y and press Enter.
•
To accept the displayed default value, press Enter.
•
To change the value, type the desired number of seconds (64 through 1024) and press
•
Enter.
(on page 5-10).
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
Step 5:
5-9