Cisco SCE 2000 4xGBE Installation And Configuration Manual page 129

Cisco systems sce 2000 platform installation and configuration guide
Table of Contents

Advertisement

Chapter 8
Troubleshooting
CLI command
show access-lists
• Telnet
• CLI command
connection
show interface mng
cannot be
established
• Mng LINK LED
is not lit (link is
down)
• Telnet
CLI command:
connection
show telnet status
cannot be
established
• Mng LINK LED
is lit (link is up)
CLI command:
show telnet
sessions
CLI command:
show ip default-
gateway
CLI command:
show ip route
<host-ip-address>
CLI commands:
• show access-
• show line vty
OL-7824-04
An ACL may be assigned
that denies entry.
Management interface IP
address or subnet mask is
incorrect.
Telnet server is disabled.
Too many Telnet connections
(up to 5 concurrent sessions
are supported).
Default gateway is incorrect
(when the host used as client
is not in the same network as
the SCE Platform).
Routing tables are incorrectly
configured (when the host
used as client is not in the
same network as the SCE
Platform, and there is more
than one gateway on the SCE
Platform network).
Host is not a member of a
valid access-list.
lists
access-class
show ip access-
class
Problem Solving Using a Subsystems Approach
Cisco SCE 2000 4xGBE Installation and Configuration Guide
See
Initial System Configuration
5-3)
Refer to "Access Control Lists" in the
Cisco Service Control Engine (SCE)
Software Configuration Guide.
Check / reconfigure management port IP
address and subnet mask
Enable Telnet server:
service telnetd
Close one or more of the open Telnet
sessions.
Check / reconfigure default gateway.
See
Initial System Configuration
5-3)
Refer to "IP Configuration" in the Cisco
Service Control Engine (SCE) Software
Configuration Guide.
Check / reconfigure routing tables.
See
Initial System Configuration
5-3)
Refer to "IP Configuration" in the Cisco
Service Control Engine (SCE) Software
Configuration Guide.
Check / reconfigure access-list.
See
Initial System Configuration
5-3)
Refer to "Access Control Lists" in the
Cisco Service Control Engine (SCE)
Software Configuration Guide.
(on page
(on page
(on page
(on page
8-13

Advertisement

Table of Contents
loading

Table of Contents