Modular Component Removal And Replacement; Tools Required - Eads Racal Instruments 1264C Manual

Modular
Component
Removal and
Replacement

Tools Required

Maintenance 5-4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1. Pry off the plastic grill retaining the supply fan filter. Use
a flat blade screwdriver if necessary.
2. Remove the supply fan filter towards the rear.
3. Clean the supply fan filter by washing in mild soap
solution, vacuuming or blowing air through the filter.
Rinse the filter with water and dry before replacing it in
the mainframe.
The following procedures describe how to remove and replace
module-level components of the 1264C Mainframe. Perform these
procedures only as necessary as part of installation (e.g. fuse
replacement), mainframe service, or repair. Refer to the Assembly
Drawings in this chapter for an overview of the assembly and
disassembly of the mainframe. See Troubleshooting for assistance
in fault isolation.
Always power off the mainframe and disconnect the power
cord before cleaning or servicing the mainframe.
The only tools required to disassemble the 1264C chassis to the
module level are a medium flat blade and Phillips screwdriver.
1264C User Manual
CAUTION:
EADS North America Defense
Test and Services, Inc. © 1998