Advertisement
7.
Attach Front Floor Runners to completed floor frame with notch aligned
flush with corner of floor framing and edge overhanging front by 2".
The overhanging edge of the front floor runners will be used later to support
the sliding door track. Attach with 6 - 2 1/2" Screws per Runner.
8.
Attach Floor Runners to completed floor frame as shown
above. Make sure Runners are flush with side and rear of
floor framing but not overhanging. Use 6 - 2 1/2" Screws per
Runner.
Concrete Slab
Foundation
9.
With Floor Runners attached, carefully flip the floor over and place on your foundation.
Caution: you will need 2 people to assist you. Be careful when laying floor down not to bend or twist floor.
When in place, level floor completely.
Toll Free 1-888-658-1658
Door Side
www.outdoorlivingtoday.com
Page 9
Parts
Front Floor Runners
(1 1/2" x 5 1/2" x 68 3/16") x 2
Hardware
S1 - 2 1/2" Screws x 12 total
Parts
Floor Runners
(1 1/2" x 3 1/2" x 68 3/16") x 8
Hardware
S1 - 2 1/2" Screws x 48 total
Foundations
Note: The floor will be flipped over
and the floor runners will sit on your
foundation. It is important to note that
having a level foundation is critical.
Choosing a foundation will vary
between regions.
See page 3 of this assembly manual
for more information on foundations.
sales@outdoorlivingtoday.com
Advertisement
