Advertisement
13.
For each Solid Wall Panel, carefully lay panel
face down. Position and attach a Bottom Wall
Plate to bottom of wall studs of each wall panel with
3 - 2 1/2" Screws. Position so plates are flush with
framing. Wall siding will overhang bottom wall plate.
1st Rear
Wall Panel
14.
Starting at Rear Corner, position a Solid Wall Panel
on top of plywood floor. The Wall Panel bottom framing
will sit flush with plywood. Wall siding will overhang the
floor. The Rear Wall panels will sit flush at the end of the
plywood floor with the side wall panels sandwiched
between them
Note: Siding will overhang the floor by approximately
4 1/2".
Toll Free 1-888-658-1658
Important:
Pilot hole ALL 2x3 Wall
Studs with 1/8" drill bit prior
to screwing. This will make it
much easier to attach
together.
Bottom Wall Plate
(1 1/2" x 2 1/2" x 45 1/2") x 7
www.outdoorlivingtoday.com
Page 12
Parts
Solid Wall Panels
(45 1/2" x 75") x 7
Bottom Wall Plates
Important - Make sure all walls are aligned
in their upright position. If not, water may
leak into your shed. Unsure if panel is
facing up or down? Wall siding overhangs
the base of the wall.
1st Rear Wall Panel
sales@outdoorlivingtoday.com
Pilot Hole
first.
Hardware
S1 - 2 1/2" Screws
x 21 total
4 1/2" overhang
Flush with
Floor Framing
Advertisement
