Advertisement
Offset Metal Ridge
Board Connectors
34.
At the peak, align Ridge Boards so they are flush together and secure
them with 12 - 1 1/4" screws. To completely secure Ridge Boards, place
4 - 1 1/4" screws into any of the remaining Metal Ridge Board Connector
holes. Complete both sides. Important: If there is a gap between Ridge
Boards, try pushing side walls closer together from outside. Walls should be
91" apart at top from inside of wall plate to wall plate.
Important: If gable framing does not line up with Rafters, remove temporary 2" screws from
Gable framing. Re-align gable and secure with 8 - 2" screws total.
35.
With both Ridge Boards connected, completely secure Rafters to
Gable framing of both Gable Walls. Use 8 - 2" screws per gable.
Toll Free 1-888-658-1658
www.outdoorlivingtoday.com
Page 23
Hardware (Step 34)
S2 - 1 1/4" Screws
x 16 total
Hardware (Step 35)
S3 - 2" Screws
x 32 total
sales@outdoorlivingtoday.com
Advertisement
