Advertisement
Advice: Prior to fastening walls and installing rafters, take time to confirm your walls are level, square and plumb.
Measure diagonal at top and bottom of walls corner-to-corner. This should be approximately 159 7/8". More importantly,
if measurements are not within 1/4", your walls are not square. Adjusting now will make it easier to install roof section
22.
When all walls are attached together, check alignment with the floor. Bottom of
wall frames should sit flush with outside of floor framing, with siding overhanging by
approximately 4 1/2".
positioned correctly, fasten Bottom Wall Plates to floor using 4 - 2 1/2" Screws per
wall panel.
23.
Position Side Top Plates (one side only) on top of wall studs so they are flush on the inside.
There are 3 Side Top Plate pieces per side (2 angle cut on one end and one straight cut - both
ends). Together, the plates should be centered evenly on the wall left to right. Attach by screwing
down into top wall framing with 3 - 2" Screws per plate.
Side Wall Top Plates - 4 Angle Cut End, 2 Straight Cut
Front & Rear Wall Top Plates - Angle Cut Edge
(3/4" x 2 1/2" x 65 3/4") x 4
Toll Free 1-888-658-1658
Pilot Hole
first.
Angle
screws into perimeter
Floor Joists.
Confirm 66 1/2" wide door opening at bottom.
Parts (Steps 23 - 24)
(3/4" x 2 1/2" x 32") x 6
www.outdoorlivingtoday.com
Hardware (Steps 23 - 24)
Page 17
Hardware
S1 - 2 1/2" Screws
x 38 total
When
S3 - 2" Screws
x 34 total
sales@outdoorlivingtoday.com
.
Advertisement
