Maico ERO-SCAN Operation Manual page 44

5.8.2.1 Understanding the Thermal Printout (DPOAE)
The following information is provided for each test (Figure 15):
Figure 40
1
8106556 Rev. 11
Operation Manual ERO•SCAN
1. Manufacturer Logo
2. The software version number (e.g.: V105.05)
3. The time and date of the test, based on the setting
of the internal clock; if the clock is set correctly,
this time and date will be correct
4. The test number (if operating in Save 500 mode)
(e.g.:001)
5. The protocol selected (e.g.: DP 2.0 - 5.0)
6. The averaging time used for this test (e.g.: 4 sec
avg.)
7. Device/Probe serial number (SN)
8. The ear selected (Right or Left)
9. A PASS/REFER indication if there is a criterion set
for the selected protocol
10. Graphic display of results
11. Printout notification when Minimum Amplitude is
'On' (e.g.: MIN*)
12. The f2 frequency in kHz (e.g.: 2.0, 3,0, 4.0, 5.0)
13. SPL of presented tones (L1, L2)
14. The level of the emission in dB SPL (DP)
15. The noise floor in dB SPL (NF)
16. The signal-to-noise ratio (SNR) = DP – NF
17. A "P" indicates that the frequency passed based
on the criterion settings within the selected
protocol
42
®
13//08/2020