The ERO•SCAN
®
allows the user to select from two options for viewing the results:
• the Graph SNR view
• the Graph Value view.
Figure 26
Figure 27
Section 5.10.2.8
5.7.2 Selecting the Test Protocol
Figure 28
Figure 29
NOTE: Some protocols of the Diagnostic Version are customizable.
Section 6.5
Section 5.10.3
1
8106556 Rev. 11
Operation Manual ERO•SCAN
Graph SNR view
The Graph SNR view (Figure 26) shows the signal-to-noise
ratio for each DP test frequency or TE test band.
The set of bars display the emissions measured. This can be
reviewed after a measurement. Each column represents one
test frequency (DP) or frequency band (TE).
Graph Value view
The Graph Value view shows the absolute emission and
noise levels for each DP test frequency or TE test band
(Figure 27).
Graph Style (Settings)
The currently selected protocol is shown on the Main Menu
(). To select another protocol press:
CHANGE
to proceed to the next screen ().
CHANGE to select another protocol.
UP
to return to the Main Menu and start testing
OR
SETUP
to enter the Setup menu.
Configurations and Test Protocols
Advanced Settings Menus (Diagnostic Version only)
35
®
13//08/2020