Maico ERO-SCAN Operation Manual page 22

Table 3 Display Messages
Display Message
Attach Probe
Wireless Device
Not Found
Wireless Error
#xxx
Wireless Not
Configured
Device not
Responding
Due For Service
1
8106556 Rev. 11
Operation Manual ERO•SCAN
Explanation
Probe is not detected.
• Check that the probe connector is fully seated in the
socket.
• Disconnect and reconnect the probe.
• Restart the device.
The paired wireless device cannot be detected. The device
may be turned off or too far away.
Paired to Printer:
• Check that the printer is turned on.
• Move closer to the printer.
• Recycle printer's power (press Power button until all
lights are off, then press Power for steady green).
• Try again.
Paired to PC or wireless connectivity dongle:
• Check that the serial port is open. Establishing the
serial port is handled by the PC and/or the software,
not by the ERO•SCAN
There is an error condition with the wireless device.
• Check wireless device (printer or PC) status.
• Attempt to connect to wireless device again.
Printing has been attempted, but no wireless device is paired
with the ERO•SCAN
• Pair the ERO•SCAN
The printer is not responding to queries from the device.
• Check printer status.
• Awaken printer from sleep mode.
• Charge printer battery if necessary.
Indicates that the calibration of the device is recommended.
Message appears upon the calibration due date set in the
device. Message appears during device startup once per day.
• Have the device calibrated by a service technician
authorized by MAICO.
20
®
.
®
.
®
.with the wireless device.
®
13//08/2020