Table of Contents
Advertisement
3.1 Examining
3.1.1 TransForm SCN
The front:
red LED 1:
1
green LED 2:
2
green LED 3:
3
green LED 4:
4
red LED 5:
5
green LED 6:
6
green LED 7:
7
green LED 8:
8
DVI in
9
DVI out
10
USB (for keyboard and mouse connection)
11
ventilation slots
12
On the front panel of TransForm SCN there are eight LEDs [1-8], indicating the operating state of the device. On
the left side there is a DVI in connector [9] and a DVI out connector [10] to insert and loop through the source
signal. On the right side there is a USB connector [11] for remote operation of the screen content.
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
12
9
10
temperature
on – temperature error
DDC Hot Plug detect
on – display is connected and generates hot plug signal
off – display is not connected or display does not support hot plug signal
signal detection
on – analog or digital Sync detected
off – no Sync detected
Ethernet activity
blinking – Ethernet activity
Fan
on – fan error
on, LED 1 and LED 5 blinking – internal error
software heartbeat
blinking – OK, otherwise there is an internal firmware error
input type
on – analog input
off – digital input
power
on – power OK
________________________________________________________________________________________________
1
2 3 4
12
5 6 7 8
3. Getting started
Figure 3-1
front view of TransForm SCN
3-2
Advertisement
Table of Contents
