Barco TransForm SCN User Manual page 37

Maximum DDC Timing
Timing
T
RANS
If you connected an analog source and the loop through is connected to a digital display,
the timing settings entered above are used to create the digital signal. Therefore, if you are
not satisfied with the quality of the image of your digital displaying device, re-check the
timing settings please.
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
T F SCN forwards DDC data from a DDC capable displaying device towards
RANS ORM
the data source. In case there is no monitor connected to the T
that it does not provide DDC data, the T
request a special resolution, please refer to section
Select a resolution for DDC from the list.
F SCN web interface – encoder timing – properties with auto detection enabled (left) and disabled (right)
ORM
_______________________________________________________________________________________________
RANS
F SCN may create a DDC signal to
RANS ORM
4.1.2 DDC.
4. Operating
F SCN or
ORM
Figure 4-10
4-14