Table of Contents
Advertisement
6.1 Initial configuration of the network settings
The T
F
SCN comes with preconfigured network settings. Before connecting the T
RANS
ORM
work, these network settings have to get adapted to suit to the company's network. It has to be distinguished
between connection to a network with or without DHCP server.
Connecting to a network with DHCP server
There are two different ways to configure the network settings. Either the DHCP server assigns the T
an arbitrary IP address:
•
Connect the T
F
RANS
ORM
•
Ask your service personnel to provide you with the assigned IP address of the T
•
Use the IP address to connect to the T
Or the DHCP server can be configured to assign a specific IP address. Therefore its MAC address is required:
•
Look on the underneath of the T
•
Configure the DHCP server to use the desired IP address with the MAC address of the T
•
Connect the T
F
RANS
ORM
•
Use the IP address to connect to the T
Connecting to a network without DHCP server
For the configuration you need a crossed network cable to connect a PC to the T
steps below.
•
First consult the network administrator to get a valid IP address.
•
Disconnect your PC from the LAN.
•
Configure the network settings of the PC in a way that it is suitable for the network settings of the
T
F
SCN, i.e. use the same net mask as the T
RANS
ORM
range. Below you find the factory set network settings of the T
IP address
net mask
default gateway
•
Connect the network connectors of the PC and of the T
•
Connect the T
F
RANS
ORM
•
As soon as the T
RANS
the T
F
SCN web interface, please refer to section
RANS
ORM
•
When the network settings are changed, disconnect the crossed network cable from the T
connect the T
F
RANS
ORM
•
Readjust the network settings of your PC and reconnect it to the network.
The network settings will be activated only, if IP address and default gateway are configured correctly. That is, if
they belong to the same subnet.
If a TransForm SCN, which is configured to have an IP address assigned via DHCP is
connected to a network without DHCP server, it uses its last received IP address instead!
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
SCN to the network. The DHCP server will assign it an IP address.
F
RANS
ORM
F
SCN. There its MAC address is labeled.
RANS
ORM
SCN to the network. The DHCP server will assign it the desired IP address.
F
RANS
ORM
10.0.0.2
255.255.255.192
10.0.0.254
SCN to the power supply; please refer to section
F
SCN is operable you can change the network settings of the T
ORM
SCN to the intended network.
________________________________________________________________________________________________
SCN.
SCN.
F
SCN and an IP address within the same address
RANS
ORM
F
RANS
ORM
F
SCN [14] with a crossed network cable.
RANS
ORM
4.3.4 Network
settings.
6. Advanced configuration
F
SCN to the net-
RANS
ORM
RANS
F
SCN.
RANS
ORM
F
SCN.
RANS
ORM
F
SCN. Please follow the
RANS
ORM
SCN:
factory set network settings
3.2.1 Power
supply.
F
RANS
ORM
F
RANS
ORM
F
SCN
ORM
Table 6-1
SCN with
SCN and
6-2
Advertisement
Table of Contents
