Resetting Factory Settings - Barco TransForm SCN User Manual

6.2 Resetting factory settings

To reset the T F SCN to factory settings the following procedure can be used.
RANS ORM
•
Disconnect the T
RANS
On the right side face of the T
•
Push the reset button. Use a lean, non-metallic object for this purpose.
•
Keep the reset button pressed while you reconnect the T
•
Stop pressing the reset button
•
Wait until all the LEDs light up
•
Wait till the T F
RANS ORM
•
Disconnect the T
RANS
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
F SCN from the power supply; please refer to section
ORM
F SCN there is a small hole with the reset button [19] in it.
RANS ORM
T F SCN – side view, front panel is shown on the left, back panel is shown on the right
RANS ORM
SCN is back to operating state
F SCN once again from the power supply and reconnect it.
ORM
________________________________________________________________________________________________
19
F SCN to the power supply.
RANS ORM
6. Advanced configuration
3.2.1 Power supply.
Figure 6-1
6-3