Prog Display - Jeio tech TC-ME-025 Operating Manual

4.2.2.2 PROG Displays
PROG STOP
PROG STOP
PROG mode : Control temperature and humidity with program.
PTNO : It indicates PATTERN number which is set.
Press SET KEY to set.
SEGNO : It indicates number of start SEGMENT.
READY : It indicates stand-by status. Unit can starts or stops running by pressing
RUN/STOP key.
PROG RUNNING THE FIRST SCREEN
PROG RUNNING : Indicates screen that the unit is running.
P/S : Indicates PATTERN/SEGMENT
P.TM(PROCESS TIME) : Indicates running time
PROG RUNNING THE SECOND SCREEN.
R.PID : Indicates running PID no. (Refer to figure 12)
RM.TM : Indicates remaining time of operation.
TS : Indicates current condition of Time Signal
IS : Indicates current condition of Inner Signal
PROG RUNNING THE THIRD SCREEN
HOLD ON: It indicates current holding PT and SEG.
HOLD OFF: It indicates RUNNING status.
S.AL : Indicates the current condition of Segment Alarm Signal
AL : Indicates the current condition of Alarm Signal
PROG RUNNING(Forth screen)
HOLD : Current SP(set point) can be HOLD ON or HOLD OFF.
STEP : Stop current segment and move to next segment.
DOWN : Indicates period of decrease of set value.
SOAK : Indicates maintenance of set value.
UP : Indicates period of increase of set value.
WAIT : Indicates stand-by condition
PROG STOP
PATTERN : Indicates the running is done.