Uniformed Distribution Of Temp. & Humid.(Up-Down Flow Type); Designed For Enhanced User's Convenience; Safety Functions - Jeio tech TC-ME-025 Operating Manual

2.2.3. Uniformed distribution of temp. & humid.(Up-down flow type)

2.2.4. Designed for enhanced user's convenience

Casters for easy transport and installation
Convenient maintenance - available to check total operating time
Magnetic door and the intensified glass door installed for viewing the internal observation.
Knob for intensified glass door was made of injection molding.
Door open warning alarm.
Cable port for running in wires.
Basic hole of 50mm diameter cable port is standard equipped on left side of chambers for wiring to the
specimen. We also provide additional 50 or 80mm diameter cable port (Optional)
Water tank for easy water supply
- Maintenance can be done easily from the front side

2.2.5. Safety functions

When the overheat alarm rings for air heater without the user's checking, the unit automatically stops
and main power is off.
When the door opens in 1 minute with an alarm signal and there is another minute passed, the unit
automatically stops because temperature & humidity inside of chamber cannot be controlled with
opening doors.
If there is the short circuit or over current unit, unit automatically stops and main power is off.
The electrical instrumentation part located in the upper panel, and motor & refrigeration part in the rear
panel of the unit, so if the door of the upper panel, or of the rear panel opens, the main power is
automatically blocked.
By the temperature regulator installed inside of chamber, if the overheated inner chamber, main power
is automatically blocked.
00HAA0001203 (Rev 1.0)
Sirocco fan adopted let it maintain the
optimal air flow inside of chamber with an
appropriate air velocity to get the suitable
temp & humid in the chamber. Opening
the door will activate the automatic stop
function of heater and fan to prevent from
contact with an external air. Air flow is
running from inhaling inner air thru the
bottom of the chamber to the vertical flow
passing thru an evaporator and heater. So
temperature & humidity inside of chamber
will controlled by the way of air flow.