How To Use Water Tank; Main Switch Panel - Jeio tech TC-ME-025 Operating Manual

2.3.4 How to use water tank(TH-ME-Type)

2.3.5 Main Switch Panel

00HAA0001203 (Rev 1.0)
Water Tank; name and function
1. Gutters: Condensed water vapor will be supplied back to the
water Tank.
2. Inlet: Pouring water into the water tank by using the funnel. See
the figure left.
3. If water is empty in the water tank, the unit give a alarm signal,
and automatically shut the power and will be stop if water is
supplied within 1 minute.
TH Chamber ; how to use Water Tank
1. Pull it out the bottom side from the front side.
2. Supply water into the water tank by using the funnel.
3. Push it back into to the original position after finish supplying
water.
Water tank : Capacity
1. TH-ME, PE - 025 : 5.0L
2. TH-ME, PE - 065 : 6.0L
3. TH-ME, PE - 100 : 9.0L
1. Over Temp. limit(for Air)
When the air temperature rises more than
Set temperature, the second main power
Will be shut.
2. Over Temp. Limit(for Water)
When the water temperature rises more than
Set temperature, the second power will be shut.
When the over temp. limit Buzzer rings, check that the product
has been overheated. If it does, request for A/S immediately.
Set the value of the over temp. limit into 10% more than that of
the setting temperature.
3. Main Switch
It is the main ON/OFF Switch.
4. COM. Port
It is RS-232/485 communication port. It will be
connected with a computer and remote controlled
the product.