Installing The New Optical Drive - HP Compaq 6005 Pro Maintenance And Service Manual

Installing the New Optical Drive

NOTE:
it, you must remove the access panel and the bezel blank covering the opening of the bay before
proceeding. Follow the procedures in
on page 42.
1. Attach the release latch to the new optical drive. Refer to
on page
2. With the back of the optical drive facing the computer and the release latch on the inner side of
the drive, align the drive with the opening in the front bezel.
3. Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1),
then connect the cable to the rear of the drive (2).
Figure 6-21
50 Chapter 6 Removal and Replacement Procedures
If you are installing an optical drive in a bay that did not previously have a drive in
49.
Installing the Optical Drive
Computer Access Panel on page 40 and Bezel Blank
Preparing the New Optical Drive