Belts (Diesel E/G On E/G Only) - Ly) - Check, Adjust - Doosan D50S-5 Operation & Maintenance Manual

Typical Example Typical Example
Typical Example Typical Example
1. 1. Clean the top of the battery and Clean the top of the battery and terminals.
2. 2. Check terminals for corrosion. Coat terminals Check terminals for corrosion. Coat terminals
with heavy grease. with heavy grease.
Maintenance Section Maintenance Section
Every 500 Service Hours or 3 Months Every 500 Service Hours or 3 Months
You must read and understand the warnings and instructions contained in the Safety section of this manual, You must read and understand the warnings and instructions contained in the Safety section of this manual,
before performing any operation or maintenance procedures. before performing any operation or maintenance procedures.
Belts (Diesel E/G Only) - Check, Belts (Diesel E/G Only) - Check,
Adjust Adjust
Typical Example Typical Example
1. 1. Install steer wheel. Put two nuts opposite each
2. 2. Inspect tightness of wheel nuts in a sequence
Drive Wheels Drive Wheels
Diesel Diesel Engine Engine Truck Truck
Typical Example Typical Example
LP LP Engine Engine Truck Truck
1. 1. Install drive wheel. Put two nuts opposite each
terminals.
2. 2. Inspect tightness of wheel nuts in a sequence
179 179
Typical Example Typical Example
Install steer wheel. Put two nuts opposite each
other (180°). Tighten bolt. other (180°). Tighten bolt.
Inspect tightness of wheel nuts in a sequence
opposite each other 610 ~ 680 N.m (370~450 opposite each other 610 ~ 680 N.m (370~450
lb.ft). lb.ft).
Install drive wheel. Put two nuts opposite each
other (180°). other (180°).
Inspect tightness of wheel nuts in a sequence
opposite each other to 500~600 N.m (370~450 opposite each other to 500~600 N.m (370~450
lb.ft). lb.ft).