Doosan D50S-5 Operation & Maintenance Manual page 94

it to the floor and then fully releasing the pedal it to the floor and then fully releasing the pedal
(pedal maneuver). You must fully cycle the foot (pedal maneuver). You must fully cycle the foot
pedal three (3 3 ) times within five ( pedal three (
enable the display codes feature of the SECM. enable the display codes feature of the SECM.
Simply turn the key Simply turn the key OFF
code list will continue to repeat until the key is code list will continue to repeat until the key is
turned OFF turned OFF. An automatic code display feature is . An automatic code display feature is
activated if a foot pedal fault condition exists. This activated if a foot pedal fault condition exists. This
feature enables the service technician to view the feature enables the service technician to view the
fault codes by turning the key to the ON fault codes by turning the key to the
foot pedal malfunction is preventing the retrieval of foot pedal malfunction is preventing the retrieval of
the stored fault codes from the SECM. the stored fault codes from the SECM.
Malfunction Indicator Light (MIL) Malfunction Indicator Light (MIL)
ON ON OFF OFF
Operation Section Operation Section
Table a. MI-04 Diagnostic Fault Codes (Flash Codes) Table a. MI-04 Diagnostic Fault Codes (Flash Codes)
DFC DFC
12 12 NONE NONE
Signifies the end of one pass Signifies the end of one pass
) times within five (5 5 ) seconds to ) seconds to
OFF to exit display mode. The to exit display mode. The
ON position, if a position, if a
ON ON ON ON OFF OFF
Probable Fault Probable Fault
= CODE 12 = CODE 12
93 93
Action Action
NONE NONE
Corrective Action, Corrective Action, First First Check
None, used None, used as as a a beginning beginning and
of the fault list identification of the fault list identification
Check
and end end