Doosan D50S-5 Operation & Maintenance Manual page 125

Typical Example Typical Example
1. 1. Move the lift truck slowly FORWARD into Move the lift truck slowly FORWARD into
position and engage the load. The truck should position and engage the load. The truck should
be square with load, forks spaced evenly be square with load, forks spaced evenly
between pallet stringers and as far apart as load between pallet stringers and as far apart as load
permits. permits.
Typical Example Typical Example
2. 2. Move the lift truck FORWARD until the load Move the lift truck FORWARD until the load
touches the carriage. touches the carriage.
Traveling with the Load Traveling with the Load
Travel with the load as low as possible, while still Travel with the load as low as possible, while still
maintaining ground clearance. maintaining ground clearance.
NOTICE NOTICE
Typical Example Typical Example
2. 2. Tilt the mast further back to cradle the loa Tilt the mast further back to cradle the load d
Typical Example Typical Example
3. 3. Operate the lift truck in reverse until the load is Operate the lift truck in reverse until the load is
clear of the other material. clear of the other material.
4. 4. Lower the cradled load to the travel posi Lower the cradled load to the travel position.
NOTE: NOTE: Lift and tilt speeds are controlled by engine Lift and tilt speeds are controlled by engine
rpm. rpm.
124 124
Unloading Unloading
tion.
Operation Section Operation Section