Every 500 Service Hours Or 3 Months; Belts - Check, Adjust; Tilt Cylinders - Check, Adjust, Lubricate - Doosan GC15S-5 Operation & Maintenance Manual

Every 500 Service Hours or 3 Months

You must read and understand the warnings and instructions contained in the Safety section of this manual,
before performing any operation or maintenance procedures.

Belts - Check, Adjust

Typical Example
1. Check the condition and adjustment of the belt.
Correct adjustment allows 12mm (0.47 inch)
deflection under 98N(22lb) of force.
Typical Example
NOTICE
Failure to loosen the alternator mounting bolt
will cause excessive stress and break the alter-
nator mounting ear.
2. To adjust the alternator drive belt, loosen
adjusting bracket bolt and mounting bolt. Move
the alternator in or out as required. Tighten bolts.
Tilt Cylinders - Check, Adjust,
Lubricate
Chassis Pivot Eyebolts - Lubricate
1. Remove floor plates.
2. Lubricate two fittings for the pivot eyebolts, one
on each tilt cylinder.
3. Check the pivot eye pins for loose retainer bolts
and wear.
Mast Pivot Eyes-Lubricate
1. Lubricate two fittings for the mast pivot eyes,
one on each side of the mast.
2. Check the pivot eye pins for loose retainer bolts
and wear.
125
Maintenance section