Doosan D50S-5 Operation & Maintenance Manual page 130

possible. Position the load evenly on both forks. possible. Position the load evenly on both forks.
Typical Example of Shaft type Fork Typical Example of Shaft type Fork
Typical Example of Hook-on type Fork Typical Example of Hook-on type Fork
1. 1. Move up the hook pin(1) in each fork to slide the Move up the hook pin(1) in each fork to slide the
fork(2) on the carriage bar. fork(2) on the carriage bar.
2. 2. Adjust the forks in the position most appropriate Adjust the forks in the position most appropriate
for the load and as wide as possible for load for the load and as wide as possible for load
stability. stability.
3. 3. When adjusting the forks, make sure that the When adjusting the forks, make sure that the
weight of the load is centered on the truck. weight of the load is centered on the truck.
4. 4. After adjustment, set the hook pins to keep the After adjustment, set the hook pins to keep the
forks in place. forks in place.
Operation Section Operation Section
Storage Information Storage Information
Before Storage Before Storage
Before storing your lift truck, clean and inspect as Before storing your lift truck, clean and inspect as
per the following procedures. per the following procedures.
1. 1. Wipe away grease, oil, etc. adhering to the body Wipe away grease, oil, etc. adhering to the body
of the truck with waste cloth, and use water, if of the truck with waste cloth, and use water, if
needed. needed.
129 129
5. 5. Cover components such as the breather and air Cover components such as the breather and air
cleaner which may be caught with humidity. cleaner which may be caught with humidity.
6. 6. The machine should be operated at least once a The machine should be operated at least once a
week. Fill the cooling system, if cooling water is week. Fill the cooling system, if cooling water is
discharged, and mount the battery. Start the discharged, and mount the battery. Start the
engine and warm up thoroughly. Move the engine and warm up thoroughly. Move the
machine a little forwards and backwards. Operate machine a little forwards and backwards. Operate
the hydraulic controls several times. the hydraulic controls several times.