Doosan D50S-5 Operation & Maintenance Manual page 155

Typical Example Typical Example
1. 1. Raise the left side cover. Raise the left side cover.
2. 2. Remove the filter cap assembly. Separate the Remove the filter cap assembly. Separate the
cap from the screen. Clean both in clean, cap from the screen. Clean both in clean,
nonflammable solvent. nonflammable solvent.
3. 3. Dry and assemble cap and screen. Dry and assemble cap and screen.
4. 4. Install cap assembly. Install cap assembly.
Fuel leaked or spilled onto hot surfaces or Fuel leaked or spilled onto hot surfaces or
electrical components can cause a fire. electrical components can cause a fire.
5. 5. Drain moisture and sediment from fuel tank as Drain moisture and sediment from fuel tank as
required by prevailing conditions. required by prevailing conditions.
Fuses, Bulbs & Circuit Breaker - Fuses, Bulbs & Circuit Breaker -
Change, Reset Change, Reset
Fuses Fuses
NOTE: If a fuse filament separates, use only the NOTE:
If a fuse filament separates, use only the
same type and size fuses for replacement. same type and size fuses for replacement.
If the filament in a new fuse separates. have If the filament in a new fuse separates. have
the circuits and instruments checked. the circuits and instruments checked.
Always replace fuses with ones of the correct Always replace fuses with ones of the correct
ampere rating. ampere rating.
WARNING WARNING
NOTICE NOTICE
Check the operation of the seat adjuster rod. Make Check the operation of the seat adjuster rod. Make
sure that the seat slides freely on its track. Lightly oil sure that the seat slides freely on its track. Lightly oil
the seat slider tracks if necessary. the seat sli der tracks if necessary.
154 154
Fuse & Relay ( LP Engine Only) Fuse & Relay ( LP Engine Only)
(1)Relay (1)Relay
(2)Fuse (2)Fuse
Maintenance Section Maintenance Section